Integrated Dell Remote Access Controller 8 (iDRAC8) Version 2.00.00.00 RACADM Command Line Interface Reference Guide

setled

Description	Sets the state (blinking or not blinking) of the LED on the specified module. To run this subcommand, you must have the Configure iDRAC permission.
Synopsis	racadm setled -l <ledState>
Input	`-l` — Specifies the LED state. The values are: 0 — No Blinking 1 — Blinking
Example	From iDRAC stop LED from blinking. racadm setled -l 0 RAC0908: System ID LED blink off. From iDRAC start LED to blink. racadm setled -l 1 RAC0907: System ID LED blink on.