Image Assist Dynamic for Multiple Platforms Version 11.1 User's Guide
Restore and test image
About this task
Restoring a Dynamic image and drivers enables you to test your WIM file before you submit it to Dell factory.
NOTE:If you are restoring a Reference image, there is no option to select drivers.
NOTE:If you have included SupportAssist in your custom image, further configuration is necessary to activate SupportAssist. Therefore, SupportAssist may not be available for testing until the configuration and activation are complete. For more information about the configuration, see the
Configuring and deploying SupportAssist (Dell Image Assist) section in the
SupportAssist for Business PCs Deployment Guide available on the
SupportAssist for Business PCs documentation page.
Steps
- Boot to the Image Assist Dynamic USB drive or ISO file.
-
On the
Welcome to Image Assist Dynamic WinPE page, in the
Restore Image card, click
RESTORE.
The Restore Image page is displayed.
- Click BROWSE, select the WIM file that you want to restore, and then click OK.
-
Click
BROWSE, go to the location where the driver is saved, and then click
OK.
NOTE:If a valid driver pack is not detected, an error message is displayed.
- To edit the partitions, click EDIT PARTITIONS.
-
Click
RESTORE IMAGE.
After the image is restored, a confirmation window is displayed.
-
In the
Restore process complete window, perform one of the following steps:
- Click SHUT DOWN to turn off the system.
- Click REBOOT to immediately restart the restored system.
请提供评级（1-5星）。
请提供评级（1-5星）。
请提供评级（1-5星）。
请选择这篇文章是否有帮助。
注释中不得包含以下特殊字符：<>()\