Ana içeriğe atla
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

Configuring Power Cap Policy Using iDRAC Settings Utility

To view and configure power policies:
  1. In iDRAC Settings utility, go to Power Configuration.
    • NOTE: The Power Configuration link is available only if the server power supply unit supports power monitoring.
    The iDRAC Settings Power Configuration page is displayed.
  2. Select Enabled to enable the iDRAC Power Limit Policy. Else, select Disabled.
  3. Use the recommended settings, or under User Defined Limits , enter the required limits. For more information about the options, see the iDRAC Settings Utility Online Help .
  4. Click Back, click Finish, and then click Yes. The power cap values are configured.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\