Preskočiť na hlavný obsah
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.

Latitude 5540 Owner's Manual

Removing the sensor board

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM card.
  3. Remove the base cover.
  4. Remove the 4G WWAN card or 5G WWAN card, as applicable.
  5. Remove the WLAN card.
  6. Remove the display assembly.
  7. Remove the display bezel.
  8. Remove the display panel.

About this task

The following images indicate the location of the sensor board and provide a visual representation of the removal procedure.
Image: Removing the display cable

Steps

  1. Remove the sensor-board cable from the routing guides on the display back cover.
  2. Lift the sensor board, along with its cable, off the display back cover.

Ohodnotiť tento obsah

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
0/3000 characters
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, či vám článok pomohol alebo nie.
  Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\