Preskočiť na hlavný obsah
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.

Latitude 5540 Owner's Manual

Installing the assembly-inner frame

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the assembly-inner frame and provide a visual representation of the installation procedure.
Image: Installing the assembly inner frame
Image: Installing the assembly inner frame

Steps

  1. Align the screw holes on the assembly-inner frame with the screw holes on the system board and the palm-rest assembly.
  2. Replace the twelve screws (M2x3) that secure the assembly-inner frame to the palm-rest assembly.
  3. Connect the speaker cable to the system board.
  4. Route the speaker cables through the routing guides on the palm-rest assembly.
  5. Route the antenna cables through the routing guides on the palm-rest assembly.

Next steps

  1. Install the WLAN card.
  2. Install the 4G WWAN card or 5G WWAN card, as applicable.
  3. Install the battery.
  4. Install the base cover.
  5. Install the SIM card.
  6. Follow the procedure in After working inside your computer.

Ohodnotiť tento obsah

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
0/3000 characters
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, či vám článok pomohol alebo nie.
  Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\