Preskočiť na hlavný obsah
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.

Latitude 5440 Owner's Manual

Installing the battery

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.

Figure 1. Installing the battery
Image: Installing the battery

Steps

  1. Using the alignment posts, place the battery on the palm-rest assembly.
  2. Align the screw holes on the battery with the screw holes on the palm-rest assembly.
  3. Tighten the five captive screws that secure the battery to the palm-rest assembly.
  4. Connect the battery cable to the system board.
  5. Adhere the tape that secures the battery cable to the battery.

Next steps

  1. Install the base cover.
  2. Install the nanoSIM card.
  3. Follow the procedure in After working inside your computer.

Ohodnotiť tento obsah

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
0/3000 characters
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, či vám článok pomohol alebo nie.
  Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\