Preskočiť na hlavný obsah
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.

Latitude 5440 Owner's Manual

Installing the display hinges

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the display hinges and provide a visual representation of the installation procedure.
Figure 1. Installing the display hinges
Image: Installing the display hinges

Steps

  1. Align the screw hole on the left hinge with the screw hole on the display back cover.
  2. Replace the two screws (M2.5x3) to secure the left hinge to the display back cover.
  3. Align the screw hole on the right hinge with the screw hole on the display back cover.
  4. Replace the two screws (M2.5x3) to secure the right hinge to the display back cover.

Next steps

  1. Install the display panel.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the WWAN card.
  5. Install the wireless card.
  6. Install the base cover.
  7. Install the nanoSIM card.
  8. Follow the procedure in After working inside your computer.

Ohodnotiť tento obsah

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
0/3000 characters
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
  Vyberte, prosím, či vám článok pomohol alebo nie.
  Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\