The computer features a chassis intrusion switch, which is able to detect any time the base cover has been removed from the computer.
Alerts to notify you of any intrusions can be enabled through the
Chassis Intrusion field in the
Security sub-menu of the BIOS setup menu.
When enabled, the
Block Boot Until Cleared field allows you to choose whether to prevent normal boot up of the system until the intrusion alert is cleared.
Figure 1. Security tabFigure 2. Alert message
If
Block Boot Until Cleared is set to
OFF, select
Continue to boot up normally or
BIOS-Setup to clear the alert.
Figure 3. Alert message
NOTE: If
Continue is selected, you will continue to see the alert each time the computer is turned on until the alert is cleared.
To clear the alert, select
ON in the
Clear Intrusion Warning field in the
Security sub-menu of the BIOS setup menu.
Figure 4. Security tab
Údaje k tejto téme nie sú k dispozícii.
Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
Vyberte, prosím, či vám článok pomohol alebo nie.
Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\