Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell Chassis Management Controller Version 3.0 for Dell EMC PowerEdge VRTX User's Guide

PDF

Enabling FIPS Mode Using CMC Web Interface

To enable FIPS:
  1. In the left pane, click Chassis Overview.
    The Chassis Health page is displayed.
  2. On the menu bar, click Network.
    The Network Configuration page is displayed.
  3. Under the Federal Information Processing Standards (FIPS) section, from the FIPS Mode drop-down menu, select Enabled.
    A message is displayed that enabling FIPS resets CMC to the default settings.
  4. Click OK to proceed.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\