Pular para o conteúdo principal
Sair

Boas-vindas à Dell

Minha conta
  • Faça pedidos de forma rápida e simples
  • Visualize os pedidos e acompanhe o status de envio
  • Crie e acesse uma lista dos seus produtos
Login Crie sua conta Premier login Inscrição no programa de parceria
Fale Conosco

Seus carrinhos no Dell.com

Dell PowerEdge R750 Installation and Service Manual

PDF

Installing R1 and R3 paddle cards

R1 and R3 paddle cards are supported on 16 x 2.5-inch NVMe direct-attach configuration only.

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
  4. Remove cooling fan cage assembly.
    NOTE:Observe the cable routing before disconnecting the cables.
  5. Remove the paddle card cable from side wall bracket.
  6. Disconnect the paddle card cables from the drive backplane.

Steps

  1. Holding the edges, align the hole on the paddle cards with the guides on the system board.
  2. Lower the paddle cards into place and press until the paddle card connector is fully seated on the system board connector.
    Figure 1. Installing the R1 paddle card
    This image shows installing the R1 paddle card
    Figure 2. Installing the R3 paddle card
    This image shows installing the R3 paddle card

Next steps

  1. Connect the paddle card cables to the drive backplane.
  2. Insert the paddle card cable into the side wall bracket.
  3. Install cooling fan cage assembly.
  4. Install the air shroud or install the GPU air shroud.
  5. Follow the procedure listed in After working inside your system.

Classifique este conteúdo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
0/3000 characters
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Selecione se o artigo foi útil ou não.
  Os comentários não podem conter estes caracteres especiais: <>()\