Latitude 7290 Owner's Manual

Installing battery

1. Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.
   NOTE Route the battery cable, if the cable at the base of the battery is un routed.
2. Insert the lower edge of the battery into the slot on the chassis and then seat the battery.
3. Tighten the two (M2.0 x 5.0) screws to secure the battery to the system.
   NOTE A small battery (3-cell) has a single screw, a larger battery (4-cell) has two screws.
4. Install the base cover
5. Follow the procedure in After working inside your computer.