- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- System Overview
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit (PSU)
- Removing the Cover
- Installing the Cover
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the PCI Card
- Installing the PCI Card
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Thermal Sensor
- Installing the Thermal Sensor
- Removing the Input/Output (I/O) Panel
- Installing the Input/Output (I/O) Panel
- Removing the Air Tunnel
- Installing the Air Tunnel
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heatsink
- Installing the Heatsink
- Removing the Heatsink Fan
- Installing the Heatsink Fan
- Removing the Processor
- Installing the Processor
- Removing the System Fan
- Installing the System Fan
- Removing the PSU Card
- Installing the PSU Card
- Removing the Speaker
- Installing the Speaker
- Removing the System Board
- Installing the System Board
- System Board Components
- Additional Information
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Technical Specifications
- Contacting Dell
Dell Precision Workstation T5610 Owner's Manual
Enhanced Pre-Boot System Assessment (ePSA) Diagnostics
The ePSA diagnostics
(also known as system diagnostics) performs a complete check of your
hardware. The ePSA is embedded with the BIOS and is launched by the
BIOS internally. The embedded system diagnostics provides a set of
options for particular devices or device groups allowing you to:
- Run tests automatically or in an interactive mode
- Repeat tests
- Display or save test results
- Run thorough tests to introduce additional test options to provide extra information about the failed device(s)
- View status messages that inform you if tests are completed successfully
- View error messages that inform you of problems encountered during testing
CAUTION: Use the system diagnostics to test only your computer. Using this
program with other computers may cause invalid results or error messages.
NOTE: Some tests for
specific devices require user interaction. Always ensure that you
are present at the computer terminal when the diagnostic tests are
performed.
- Power-on the computer.
- As the computer boots, press the <F12> key as the Dell logo appears.
- On the boot menu screen, select the Diagnostics option.
The Enhanced Pre-boot System Assessment window is displayed, listing all devices detected in the computer. The diagnostics starts running the tests on all the detected devices.
- If you wish to run a diagnostic test on a specific device, press <Esc> and click Yes to stop the diagnostic test.
- Select the device from the left pane and click Run Tests.
- If there are any issues, error codes are displayed.
Note the error code and contact Dell.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
문서가 도움이 되었는지 여부를 선택하십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.