메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R730 Owner's Manual

PDF

Removing an expansion card from expansion card riser 2 or 3

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. When removing a card from riser 3, ensure that the PCIe holder latch is closed.
NOTE: The procedure for installing and removing a full length PCIe card is similar to the procedure for removing and installing a GPU card.

Steps

  1. Disconnect any cables connected to the expansion card.
  2. Lift the expansion card latch out of the guide slot.
  3. Hold the expansion card by its edges, and remove it from the expansion card connector.
  4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion card latch.
    NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions.
  5. Install the expansion card latch into the slot.
  6. Close the expansion card locking tabs.
    Figure 1. Removing an expansion card from expansion card riser 2 or 3
    This figure shows removing an expansion card from an expansion card riser 2 or 3.
    1. expansion card
    2. expansion card latch
    3. expansion card riser
    4. power connector (for GPU cards)
    5. expansion card connector

Next steps

  1. Install an expansion card into the expansion card riser.
  2. Follow the procedure listed in the After working inside your system section.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.