Dell PowerEdge R730 Owner's Manual

Installing an AC power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: The maximum output power (shown in watts) is listed on the PSU label.

Follow the safety guidelines listed in the Safety instructions section.
For systems that support redundant power supply units (PSUs), ensure that both the PSUs are of the same type and have the same maximum output power.
If installed, remove the PSU blank.

Steps

Slide the PSU into the chassis until the PSU is fully seated and the release latch snaps into place.
If applicable, relatch the cable management arm.
For information about the cable management arm, see the rack documentation of your system.
Connect the power cable to the PSU, and plug the cable into a power outlet.
CAUTION: When connecting the power cable, secure the cable with the strap.
NOTE: When installing, hot swapping, or hot-adding a new PSU, wait for 15 seconds for the system to recognize the PSU and determine its status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU is discovered and enabled before you remove the other PSU. The PSU status indicator turns green to signify that the PSU is functioning properly.
Figure 1. Installing an AC PSU
1. release latch
2. PSU cable connector
3. PSU
4. power connector
5. PSU handle

환영

환영합니다.

Dell PowerEdge R730 Owner's Manual

Installing an AC power supply unit

Prerequisites

Steps

본 콘텐츠를 평가해주십시오.