메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R630 Owner's Manual

PDF

Removing the network daughter card

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Philips #2 screwdriver handy.

Steps

  1. Remove the expansion card riser 3.
  2. Using a Phillips #2 screwdriver, loosen the two captive screws that secure the Network Daughter Card (NDC) to the system board.
  3. Hold the NDC by the edges on either side of the touch points and lift to remove it from the connector on the system board.
  4. Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
  5. Lift the NDC out of the system.
    Figure 1. Removing the NDC
    This figure shows removing the NDC.
    1. captive screw socket (2)
    2. connector on the system board
    3. captive screw (2)
    4. touch point (2)
    5. NDC
    6. back panel slots for Ethernet connectors

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.