메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R630 Owner's Manual

PDF

Removing a heat sink

Prerequisites

CAUTION Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper thermal conditions.
WARNING The heat sink is hot to touch. Allow the heat sink to cool for some time after powering down the system.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. If installed, remove the full-length PCIe card(s).
  4. Remove the cooling shroud.
  5. Keep the Phillips #2 screwdriver ready.

Steps

  1. Loosen one of the screws that secure the heat sink to the system board.
    Allow some time (approximately 30 seconds) for the heat sink to loosen from the processor.
  2. Remove the screw diagonally opposite to the screw that you first removed.
  3. Repeat step 1 and 2 for removing the remaining two screws.
  4. Remove the heat sink.
    Figure 1. Removing a heat sink
    This figure shows removing the processor heat sink.
    1. retention screw (4)
    2. heat sink
    3. processor socket
    4. retention screw slot (4)

Next steps

  1. Replace the heat sink(s) and processor(s).
  2. Replace the processor and heat sink.
  3. Follow the procedure listed in the After working inside your system section.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.