Dell PowerEdge R630 Owner's Manual

Options to set up iDRAC IP address

You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC. You can set up the IP address by using one of the following interfaces:

Interfaces: Document/Section
iDRAC Settings utility: See Integrated Dell Remote Access Controller User's Guide available at https://www.dell.com/idracmanuals
Dell Deployment Toolkit: See Dell EMC OpenManage Deployment Toolkit User's Guide available at https://www.dell.com/openmanagemanuals
Dell Lifecycle Controller: See Dell Lifecycle Controller User's Guide available at https://www.dell.com/idracmanuals
Chassis or Server LCD panel: See the LCD panel section

You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for iDRAC.

NOTE To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet connector 1 on the system board.

NOTE Ensure that you change the default user name and password after setting up the iDRAC IP address.

환영

환영합니다.

Dell PowerEdge R630 Owner's Manual

Options to set up iDRAC IP address

본 콘텐츠를 평가해주십시오.