Dell PowerEdge R630 Owner's Manual

Installing the VGA module

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE This procedure applies only to the eight hard drive system.

Follow the safety guidelines listed in the Safety instructions section.
Keep the Philips #2 screwdriver ready.

Steps

Push the VGA module into the chassis and align the threaded screw hole on the VGA module with the screw hole on the chassis.
Replace the screw (at the bottom of the chassis) that secures the VGA module to the chassis.
Replace the control panel.
Connect the VGA module cable to the VGA module.
CAUTION The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
Connect the display module cables to the control panel board.
Figure 1. Installing the VGA module
1. screw
2. VGA module cable
3. VGA module
4. control panel

Next steps

Follow the procedure listed in the After working inside your system section.

환영

환영합니다.

Dell PowerEdge R630 Owner's Manual

Installing the VGA module

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.