Dell PowerEdge R630 Owner's Manual

Installing the control panel–eight hard drive system

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in the Safety instructions section.
Keep the Philips #1 screwdriver ready.

Steps

Slide the left side of the control panel into the chassis so that the left tab on the control panel aligns with the slot on the chassis wall and the top left tab aligns with the slot on the top of the chassis.
Pull the display module cable through the opening and into the chassis.
Push the right side of the control panel until the top right tab aligns with the top of the chassis and the panel snaps into place.
Using a Philips #1 screwdriver, replace the screw (located at the bottom of the chassis) that secures the control module to the chassis.
CAUTION The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
Connect the display module cable to the control panel board.
Figure 1. Installing the control panel for eight hard drive system
1. control panel
2. notch on chassis front wall (2)
3. display module ZIF connector
4. display module cable

Next steps

Follow the procedure listed in the After working inside your system section.

환영

환영합니다.

Dell PowerEdge R630 Owner's Manual

Installing the control panel–eight hard drive system

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.