Dell PowerEdge R630 Owner's Manual

Installing the control panel board–eight hard drive system

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in the Safety instructions section.
Keep the Philips #2 screwdriver ready.

Steps

Align the screw holes on the control panel board with the standoffs on the chassis.
Replace the two screws that secure the control panel board to the chassis.
CAUTION The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
Connect control panel and display module cables to the control panel board.
If required, route the power and data cables along the chassis wall.
Figure 1. Installing the control panel board
1. control panel board
2. screws (2)
3. control panel cable
4. display module cable

Next steps

Follow the procedure listed in the After working inside your system section.

환영

환영합니다.

Dell PowerEdge R630 Owner's Manual

Installing the control panel board–eight hard drive system

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.