메인 콘텐츠로 이동
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스

Dell PowerEdge R630 Owner's Manual

Expansion card installation guidelines

Your system supports PCI Express Generation 3 expansion cards.

Table 1. Guidelines for systems supporting three PCIe expansion cardsThis table describes guidelines for systems supporting three PCIe expansion cards.
Riser PCIe Slot Processor Connection Height Length Link Width Slot Width
1 1 Processor 2 Low Profile Half Length x16 x16
1 2 Processor 2 Low Profile Half Length x8 x16
3 3 Processor 1 Low Profile Half Length x16 x16
NOTE Both the processors must be installed to use riser 1 slots.
Table 2. Guidelines for systems supporting two PCIe expansion cardsThis table describes the guidelines for systems supporting two PCIe expansion cards.
Riser PCIe Slot Processor Connection Height Length Link Width Slot Width
2 1 Processor 1 Low Profile Half Length x8 x16
Processor 2 Low Profile Half Length x16 x16
3 2 Processor 1 Full height Three-fourth Length x16 x16
NOTE Only a three-fourth length card is supported for the PCIe expansion card slot (slot 2) on riser 3 when no mini-PERC card is installed. Supported length with mini-PERC card installed is half length.
NOTE For a system with three PCIe cards, only MiniSAS HD third-party cards are supported in slot 3. For a system with two PCIe cards, only MiniSAS HD third-party cards are supported in slot 1.
NOTE You can install expansion cards only on one slot on riser 2.
NOTE Both the processors must be installed to use the x16 PCIe link on the riser 2 slot.
The following table provides a guide for installing expansion cards to ensure proper cooling and mechanical fit. Install the expansion card by following the card priority and slot priority order as shown in the table.
Table 3. Expansion card installation priorityThis table describes the guidelines to install expansion cards.
Card Priority Card Type Systems Supporting up to 2 PCIe Expansion Cards Systems Supporting up to 3 PCIe Expansion Cards
Slot Priority Max Allowed Slot Priority Max Allowed
1 PCIe Bridge N/A N/A 1 1
2 RAID 1 1 3, 1 2
3 100 G HCA/OPA HFI 1 1 3, 2 (3, 1 for CX4/OPA) 2
4 40 G NICs 2, 1 2 3, 2 2
5 FC16 HBA 2, 1 2 3, 2, 1 3
6 10 Gb NICs 2, 1 2 3, 2, 1 3
7 FC8 HBA 2, 1 2 3, 2, 1 3
8 1 Gb NICs 2, 1 2 3, 2, 1 3
9 Non-RAID 12 Gb SAS 1 1 3, 1 2
10 Integrated RAID Integrated Slot 1 Integrated Slot 1
11 NDC Integrated Slot 1 Integrated Slot 1
12 NVMe PCIe SSD 1,2 2 3, 2, 1 2
NOTE To support x16 PCIe link width, the 100 G HCA/OPA HFI in slot 1 needs processor 2 and x16 center_riser2.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.