Dell PowerEdge R630 Owner's Manual

Creating a system and setup password

Prerequisites

Ensure that the password jumper is enabled. The password jumper enables or disables the system password and setup password features. For more information, see the System board jumper settings section.

NOTE If the password jumper setting is disabled, the existing system password and setup password are deleted and you need not provide the system password to boot the system.

Steps

To enter System Setup, press F2 immediately after turning on or rebooting your system.
On the System Setup Main Menu screen, click System BIOS > System Security.
On the System Security screen, verify that Password Status is set to Unlocked.
In the System Password field, type your system password, and press Enter or Tab.
Use the following guidelines to assign the system password:
- A password can have up to 32 characters.
- The password can contain the numbers 0 through 9.
- Only the following special characters are allowed: space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
A message prompts you to reenter the system password.
Reenter the system password, and click OK.
In the Setup Password field, type your setup password and press Enter or Tab.
A message prompts you to reenter the setup password.
Reenter the setup password, and click OK.
Press Esc to return to the System BIOS screen. Press Esc again.
A message prompts you to save the changes.
NOTE Password protection does not take effect until the system reboots.

환영

환영합니다.

Dell PowerEdge R630 Owner's Manual

Creating a system and setup password

Prerequisites

Steps

본 콘텐츠를 평가해주십시오.