- Notes, cautions, and warnings
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Air shroud
- Front bezel
- PCIe holder
- Intrusion switch
- Front system fan assembly
- Internal chassis speaker
- Hard disk drive and the Optical disk drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Front input and output bezel
- Front input and output panel
- Rear system fan assembly
- Right side cover
- Hard disk drive and optical disk drive frame
- Slim Optical Disk Drive
- 5.25-inch optical drive
- Power distribution and fan control board
- Front HDD cable and fan assembly
- Fan bracket
- Graphical processing unit(GPU)
- Center System fan/HDD fan
- Memory
- Coin cell battery
- Processor heat sink module
- System board
- RAID controller battery
- VROC module
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
Dell Precision 7920 Tower Owner's Manual
Installing the PCIe card holder
- Align the PCIe card holder to the slot in front of the system fan assembly, and press down until it clicks in place.
- Route the dual cables back through the clip on the PCIe card holder.
- Connect the power cables on either side to the cable slots in the PCIe card holder.
- Reinstall the full length cards if they were removed.
- If the MegaRAID 9460 was removed, please connect the Super CAP back to the card.
- Install the:
- Follow the procedure in After working inside your computer.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
문서가 도움이 되었는지 여부를 선택하십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.