Dell PowerEdge R760 Installation and Service Manual

Replacing the system battery

Prerequisites

WARNING:There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the Safety instructions that came with your system for more information.

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
If applicable, disconnect the power or data cables from the expansion cards.
Remove the expansion card risers.

Steps

Press and hold the battery socket retention latch, for the battery to pop out.
NOTE: If the battery does not pop out, then lift it out of the socket.
Figure 1. Removing the system battery
To install a new system battery, hold the battery with the positive side facing up at an angle and slide it under the battery holder socket latch.
Press the battery into the connector until it snaps into place.
Figure 2. Installing the system battery

Next steps

Install the expansion card risers.
If applicable, connect the cables to one or more expansion cards.
Follow the procedure listed in After working inside your system.
Confirm that the battery is operating properly, by performing the following steps:
1. Enter the System Setup, while booting, by pressing F2.
2. Enter the correct time and date in the System Setup Time and Date fields.
3. Exit the System Setup.
4. To test the newly installed battery, check the time and date at least an hour after installing the battery.
5. Enter the System Setup and if the time and date are still incorrect, see Getting help section.

환영

환영합니다.

Dell PowerEdge R760 Installation and Service Manual

Replacing the system battery

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.