Dell PowerEdge R760 설치 및 서비스 매뉴얼

Installing the OCP NIC card

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Remove the expansion card riser.
Disconnect OCP NIC cable from the SL11_CPU1_PB7 to SL13_CPU1_PB7 connectors on the MAX system board, if 100 GbE OCP NIC card of PCIe width x16 is used.
NOTE:See cable routing section.

CAUTION:GPU, 네트워크 카드 또는 다른 PCIe 디바이스를 Dell에서 검증 및 테스트하지 않은 시스템에 설치하지 마십시오. 미인증 및 미검증 하드웨어 설치로 인한 손상은 시스템 보증을 무효화하여 효력을 잃습니다.

If installed, remove the filler bracket.
NOTE:Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 1. Removal of filler bracket
Open the blue latch on the system board.
Slide the OCP NIC card into the slot in the system.
Push until the OCP NIC card is connected to the connector on the system board.
Close the blue latch to lock the OCP NIC card to the system.
NOTE:이미지의 숫자는 정확한 단계를 설명하지 않습니다. 이러한 숫자는 순서를 나타냅니다.
Figure 2. Installing the OCP NIC card

Connect OCP NIC cable from SL11_CPU1_PB7 to SL13_CPU1_PB7 connectors on the MAX system board, if 100 GbE OCP NIC card of PCIe width x16 is used.
NOTE:See cable routing section.
Install the expansion card riser.
Follow the procedure listed in After working inside your system.