Dell PowerEdge R760 Installation and Service Manual

Removing the rear mounting front PERC module

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Remove the cooling fan cage assembly.
Remove the drive backplane cover.
If required, remove the air shroudor remove the GPU air shroud..
Disconnect all the cables, observe the cable routing.
NOTE:See cable routing section for more information.

Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Figure 1. Removing the rear mounting front PERC module
Disconnect the battery power cable from the front PERC card.
Tilt and lift the battery holder assembly from the front PERC shroud.
NOTE:Remove the battery cable from the front PERC shroud cable holder.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 2. Removing the battery holder assembly from the PERC shroud
Press and remove the battery from the battery holder.
Figure 3. Removing the battery from the battery holder
Using a Phillips #2 screwdriver, remove the four screws on the front PERC shroud.
Remove the front PERC shroud from the PERC.card.
Remove the front PERC card from the PERC tray.
Figure 4. Removing the front PERC card