메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
  • 회사 관리를 사용하여 Dell EMC 사이트, 제품 및 제품 수준 연락처를 관리하십시오.
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R760 Installation and Service Manual

PDF

Removing the processor

Prerequisites

WARNING:Remove the processor from processor and heat sink module (PHM) only if you are replacing the processor or heat sink.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
  4. Remove the processor heat sink module.
CAUTION:You may find the CMOS battery loss or CMOS checksum error that is displayed during the first instance of powering on the system after the processor or system board replacement which is expected. To fix this, simply go to setup option to configure the system settings.

Steps

  1. Place the heat sink with the processor side facing up.
  2. Using your thumb, lift the thermal interface material (TIM) break lever to release the processor from the TIM and retaining clip.
    NOTE:For Xeon Max processor, turn the side lever (up to 60 degrees) with the flat blade screwdriver to release the Xeon Max processor from the TIM and retaining clip.
  3. Holding the processor by the edges, lift the processor away from the retaining clip.
    NOTE:Ensure to hold the retaining clip to the heat sink as you lift the TIM break lever.
    Figure 1. Removing the processor
    This image shows removing the processor
    Figure 2. Removing the Xeon Max processor
    This image shows removing the processor
    NOTE:Ensure to return the TIM break lever or side lever on the retaining clip back to original position.
  4. Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the retaining clip release tab, and then lift the retaining clip partially from the heat sink.
  5. Repeat the procedure at the remaining three corners of the retaining clip.
  6. After all the corners are released from the heat sink, lift the retaining clip from the pin 1 corner of the heat sink.
    Figure 3. Removing the retaining clip
    This image shows Removing the retaining clip
    Figure 4. Removing the Xeon Max retaining clip
    This image shows Removing the retaining clip

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.