Dell PowerEdge R760 Installation and Service Manual

Installing the VGA port

NOTE:VGA port is supported only in slot 4 of the expansion card riser.

Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
Slide the VGA port into the expansion card riser.
Figure 1. Installing the VGA port
Connect the VGA port cable to the LC rear I/O board.
Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Tighten the captive screws on the system.
Figure 2. Connecting the VGA port cable