메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
  • 회사 관리를 사용하여 Dell EMC 사이트, 제품 및 제품 수준 연락처를 관리하십시오.
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing the system board

Prerequisites

NOTE:Before replacing the system board, replace the old iDRAC MAC address label on the Express Service Tag with the iDRAC MAC address label of the replacement system board.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If you are replacing the system board, remove all the components that are listed in the removing the system board section.

Steps

  1. Unpack the new system board assembly.
    CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
    CAUTION:Take care not to damage the system identification button while placing the system board into the chassis.
  2. Holding the system board holder and plunger, lower the system board at a tilted angle into the system.
  3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
    Figure 1. Installing the system board
    This image shows Installing the system board.

Next steps

  1. Replace the following components:
    1. Trusted Platform Module (TPM)
      NOTE:The TPM Module must be replaced only while installing new system board.
    2. Internal USB card (if removed)
    3. OCP card (if removed)
    4. Processor and heat sink module or Direct Liquid Cooling module
    5. Memory modules
    6. R1 and R4 paddle cards (if removed)
    7. GPU air shroud (if removed)
    8. Expansion card risers
    9. Rear drive module
    10. VGA port (if removed)
    11. Serial COM port (if removed)
    12. BOSS-N1 module
    13. Side wall bracket
    14. Cooling fan cage assembly
    15. Air shroud
    16. Power supply units (PSU)
  2. Reconnect all cables to the system board.
    NOTE:Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing bracket.
  3. Ensure that you perform the following steps:
    1. Use the Easy Restore feature to restore the Service Tag. See the Restoring the system by using the Easy Restore feature section.
    2. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the Manually update the Service Tag by using System Setup section.
    3. Update the BIOS and iDRAC versions.
    4. Re-enable the Trusted Platform Module (TPM). See the Upgrading the Trusted Platform Module section.
  4. Follow the procedure listed in After working inside your system.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.