Dell PowerEdge R760 Installation and Service Manual

Installing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to install is similar.

Prerequisites

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
If required, remove the drive backplane cover.
If installed, remove the air shroudor remove the GPU air shroud.
Remove the cooling fan cage assembly.

NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cables properly when you replace them to prevent the cables from being pinched or crimped.

Steps

Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE:Route the cables through the side wall cable holder.
Close the side wall cable holder until the holder clicks into place.
Figure 1. Installing the side wall bracket

Next steps

Replace the cooling fan cage assembly.
If removed, install the air shroudor install the GPU air shroud.
If removed, install the drive backplane cover.
Follow the procedure listed in the After working inside your system.

환영

환영합니다.

Dell PowerEdge R760 Installation and Service Manual

Installing the side wall bracket

Prerequisites

Steps

Next steps

본 콘텐츠를 평가해주십시오.