Dell PowerEdge R760 Installation and Service Manual

Installing the right control panel

1. Align and slide the right control panel into the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
   NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
5. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel and the cable cover to the system.
   NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.