메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
  • 회사 관리를 사용하여 Dell EMC 사이트, 제품 및 제품 수준 연락처를 관리하십시오.
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing the LOM card, MIC card and rear I/O board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the system board.
NOTE:The procedure to install the liquid cooling rear I/O board and rear I/O board is the same.

Steps

  1. Align the connectors and slots on the LAN on Motherboard (LOM) card, Management Interface card (MIC), or rear I/O board with the connector and standoffs on the system board.
  2. Press the LOM card, MIC card, or rear I/O board until firmly seated on the system board connector.
  3. Using a Phillips #2 screwdriver, secure the LOM card, MIC card or rear I/O board to the system board with screws.
    Figure 1. Installing the LOM card and rear I/O board
    This image shows installing the LOM card and rear I/O board.
    Figure 2. Installing the LOM card and Liquid cooling rear I/O board
    This image shows Installing the liquid cooling rear I/O board
    Figure 3. Installing the MIC card
    Tihis image shows Installing MIC card
    NOTE:MIC is card is only available in the system that supports Dell DPU cards.

Next steps

  1. Install the system board.
  2. Follow the procedure listed in After working inside your system.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.