메인 콘텐츠로 이동
로그아웃

환영합니다.

내 계정
  • 빠르고 간편하게 주문
  • 주문 보기 및 배송 상태 추적
  • 제품 목록을 생성 및 액세스
로그인 계정 만들기 프리미어 로그인 Partner Program 로그인
문의처

Dell.com 카트

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

PDF

Updating Firmware Using Repository

You can perform multiple firmware updates by specifying a network share containing a valid repository of DUPs and a catalog describing the available DUPs. When iDRAC connects to the network share location and checks for available updates, a comparison report is generated that lists all available updates. You can then select and apply the required updates contained in the repository to the system.
Before performing an update using the repository, make sure that:
  • A repository containing Windows based update packages (DUPs) and a catalog file is created in the network share (CIFS or NFS). If a user-defined catalog file is not available, by default Catalog.xml is used.
  • Lifecycle Controller is enabled.
  • You have Server Control privilege to update firmware for devices other than iDRAC.

To update device firmware using a repository:

  1. In the iDRAC7 Web interface, go to Overview > iDRAC Settings > Update and Rollback . The Firmware Update page is displayed.
  2. On the Update tab, select Network Share as the File Location.
  3. In the Catalog Location section, enter the network setting details. For information about the fields, see the iDRAC7 Online Help .
  4. Click Check for Update. The Update Details section displays a comparison report showing the current firmware versions and the firmware versions available in the repository.
    • NOTE: Any update in the repository that is not applicable to the system or the installed hardware or not supported is not included in the comparison report.
  5. Select the required updates and do one of the following:
    • For firmware images that do not require a host system reboot, click Install. For example, .d7 firmware file.
    • For firmware images that require a host system reboot, click Install and Reboot or Install Next Reboot.
    • To cancel the firmware update, click Cancel.

    When you click Install, Install and Reboot or Install Next Reboot, the message Updating Job Queue is displayed.

  6. Click Job Queue to display the Job Queue page, where you can view and manage the staged firmware updates or click OK to refresh the current page and view the status of the firmware update.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.