- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- ME4 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI SFP+ transceivers
- Supported SAS and Twinax direct-attach cables
- Supported hard drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- Dell EMC Storage Support Policy
Dell PowerVault ME4 Series Storage System Support Matrix
Supported Fibre Channel and iSCSI direct-attach configuration operating systems
ME4 Series storage systems support Fibre Channel and iSCSI direct-attached configurations on the following operating systems:
- Microsoft Windows Server 2022
- Microsoft Windows Server 2019
- Microsoft Windows Server 2016
- Microsoft Windows Server 2012 R2
- Citrix XenServer 7.1 CU2 or later
- Red Hat Enterprise Linux 8.0 or later
- Red Hat Enterprise Linux 7.4 or later
- Red Hat Enterprise Linux 6.9 or later
- SUSE Linux Enterprise Server 15.0 or later
- SUSE Linux Enterprise Server 12.3 or later
- VMware vSphere 7.0 or later
- VMware vSphere 6.7 or later
- VMware vSphere 6.5 or later
NOTE Hyper-V supports direct-attach configurations if Hyper-V is installed as an application on Windows Server 2019. Hyper-V Server 2019 does not support direct-attach configurations.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\