Dell EMC SmartFabric OS10 User Guide Release 10.5.1

timeout-val—Valid values are from 5000 to 10000.

• The configurations are supported only in multiswitch mode.
• This timer is used to mark the error conditions during domain ID allocation, SW-RSCN, and NS QUERY. Match this value with the other end, during port initialization. This type of configuration is not permitted when vfabric is active.
• If the configured R_A_TOV value is not the same on both the sides of the port, then the port is isolated. Ensure to configure the same R_A_TOV value on both the sides.
• You can change the R_A_TOV value only when vfabric is in inactive state. You can activate the vfabric only by adding VLAN and fcmap configuration under the vfabric configuration view. Ensure to configure the R_A_TOV before configuring the vlan, and fcmap in the vfabric configuration view.
• The no version of this command resets to default value of 10000ms.

OS10(conf-vfabric-<vfabric-id>)#r_a_tov 3000