Dell EMC SmartFabric OS10 User Guide Release 10.5.1

fip-snooping port-mode {enode | enode-transit | fcf | fcf-transit}

enode | enode-transit | fcf | fcf-transit—Enter the keyword to set FIP snooping port mode.

OS10 supports this configuration only on a switch running FSB mode, and on Ethernet and port-channel interfaces. You cannot configure FIP snooping port mode on a port channel member.

Use this command to change the port mode. By default, the port mode of an interface is set to ENode. Configure the port mode only after you enable FIP snooping. Before you disable FIP snooping, reset the port mode to its default value, ENode.

You cannot disable FIP snooping when the port mode is set to a non-default value (enode-transit, fcf, or fcf-transit).

If you want to change the port mode from one value to another, you can directly use the fip-snooping port mode command. You do not have to explicitly use the no form of the command.

The no version of this command resets the port mode to ENode.

OS10(config)# interface ethernet 1/1/32
OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf