Dell EMC SmartFabric OS10 User Guide Release 10.5.1

Example: Configure boundary clock with L2 transport method

1. Configure the PTP boundary clock.

   The delay mechanism of the boundary clock is end-to-end by default.

   OS10(config)# ptp clock boundary

2. Enable PTP on interface 1 with L2 multicast transport mode.

   PTP role is dynamic by default.

   OS10(config)# interface ethernet 1/1/1
   OS10(conf-if-eth1/1/1)# ptp transport layer2
   OS10(conf-if-eth1/1/1)# ptp enable

3. Enable PTP on interface 2 with L2 multicast transport mode.

   PTP role is dynamic by default.

   OS10(config)# interface ethernet 1/1/2
   OS10(conf-if-eth1/1/2)# ptp transport layer2
   OS10(conf-if-eth1/1/2)# ptp enable