- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- ME4 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI SFP+ transceivers
- Supported SAS and Twinax direct-attach cables
- Supported hard drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- Dell EMC Storage Support Policy
Dell PowerVault ME4 Series Storage System Support Matrix
Default IPv4 Settings for management ports
NOTE No default gateway is set.
By default, the management ports on the storage system are set to DHCP. If DHCP fails, the following IPv4 settings are used:
| Controller/Port | IPv4 Address | Subnet Mask |
|---|---|---|
| Controller 0 | 10.0.0.2 | 255.255.255.0 |
| Controller 1 | 10.0.0.3 | 255.255.255.0 |
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\