Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Verify and configure IOM settings

• Verify the firmware version on the new IOM. If required, upgrade the firmware on the new IOM. To view the pending firmware upgrade, use the show image firmware command. For more information, see Install firmware upgrade.
• Configure the hostname and IP management protocols, such as SNMP and NTP on the new IOM. For more information, see System management.
  NOTE In SmartFabric Services mode, the OME-Modular GUI configurations specific to the faulty IOM apply to the new IOM. When you remove the faulty IOM, the CLI configurations are lost. Reapply the configurations in the new IOM using the OS10 CLI. SmartFabric Services mode supports all OS10 show commands and a subset of CLI configuration commands. For more information about supported commands, see Operating modes.
  NOTE When you remove the faulty IOM in Full-Switch mode, the CLI configurations are lost. Reapply the configurations in the new IOM using OS10 CLI.