Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• start-interval — Sets the minimum interval between initial sending and re-sending the same LSA in milliseconds, from 0 to 600,000.
• hold-interval — Sets the next interval to send the same LSA in milliseconds. This is the time between sending the same LSA after the start-interval is attempted, from 1 to 600,000.
• max-interval — Sets the maximum amount of time the system waits before sending the LSA in milliseconds, from 1 to 600,000.

• start-interval — 0 milliseconds
• hold-interval — 5000 milliseconds
• max-interval — 5000 milliseconds

OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# timers throttle lsa all 100 300 1000