Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Configure one interface IP address to include in all NTP packets. The source address of NTP packets is the interface IP address the system uses to reach the network by default.

• Configure a source IP address for NTP packets in CONFIGURATION mode.

  ntp source interface

  • ethernet node/slot/port[:subport]—Enter the Ethernet interface information.
  • port-channel channel-id—Enter the port-channel ID, from 1 to 128.
  • vlan vlan-id—Enter the VLAN ID number, from 1 to 4093.
  • loopback id—Enter the Loopback interface ID number, from 0 to 16383.
  • mgmt node/slot/port—Enter the physical port interface for the Management interface. The default is 1/1/1.

Configure the source IP address

OS10(config)# ntp source ethernet 1/1/10

View the source IP configuration

OS10(config)# do show running-configuration | grep source
ntp source ethernet1/1/1