Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• local engineID — Enter the engine ID that identifies the local SNMP agent on the switch as an octet colon-separated number. A maximum of 27 characters.
• remote ip-address — Enter the IPv4 or IPv6 address of a remote SNMP device that accesses the local SNMP agent.
• udp-port port-number — Enter the UDP port number on the remote device, from 0 to 65535.
• remote-engineID — Enter the engine ID that identifies the SNMP agent on a remote device, 0x then by a hexadecimal string).

The local engine ID generates the localized keys for the authentication and privilege passwords. These passwords authenticate SNMP users and encrypt SNMP messages. If you reconfigure the local Engine ID, the localized keys also change. The existing values are no longer valid, and a warning message displays. As a result, you must reconfigure SNMP users with new localized password keys.

In addition, if you change the configured engine ID for a remote device, you must reconfigure the authentication and privacy passwords for the remote user.

To display the current local engine ID, use the show snmp engineID local command.

Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.2.0. Also supported in SmartFabric mode starting in release 10.5.0.1.

OS10(config)# snmp-server engineID local 80:00:02:b8:04:61:62:63 

OS10(config)# snmp-server engineID local 80:00:02:b8:04:61:62:63 
% Warning: Localized passwords need to be regenerated for local user.

OS10(config)# snmp-server engineID remote 1.1.1.1 0xaaffcc  

OS10(config)# snmp-server engineID remote 1.1.1.2 udp-port 432 0xabeecc