Dell EMC SmartFabric OS10 User Guide Release 10.5.0

• vrf vrf-name—Enter the keyword vrf, then the name of the VRF.
• group-address—Enter the group address in dotted-decimal format (A.B.C.D).
• source-address—Enter the source address in dotted-decimal format (A.B.C.D).

• S, G—Displays the entry in the multicast PIM database
• uptime—Displays the amount of time the entry has been in the PIM route table
• expires—Displays the amount of time until the entry expires and is removed from the database
• RP—Displays the IP address of the RP or source for the entry
• Incoming interface—Displays the reverse path forwarding (RPF) interface towards the RP/source
• RPF neighbor—Displays the next hop IP address from this interface towards the RP/source
• Outgoing interface list—Lists the interfaces that meet one of the following criteria:
  • a directly connected member of the group
  • a statically connected member of the group
  • received an (*, G) or (S, G) join message

OS10# show ip pim tib

PIM Multicast Routing Table
Flags: S - Sparse, C - Connected, L - Local, P - Pruned,
       R - RP-bit set, F - Register Flag, T - SPT-bit set, J - Join SPT,
       K - Ack-Pending state
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode

(*, 225.1.1.1), uptime 13:08:24, expires 00:00:12, RP 171.1.1.1, flags: SCJ
  Incoming interface: vlan105, RPF neighbor 3.1.1.1
  Outgoing interface list:
    vlan121  Forward/Sparse  13:07:53/Never


(101.1.1.10, 225.1.1.1), uptime 13:07:51, expires 00:06:09, flags: T
  Incoming interface: vlan103, RPF neighbor 2.1.1.1
  Outgoing interface list:
    vlan121  Forward/Sparse  13:07:50/Never