Dell EMC SmartFabric OS10 User Guide Release 10.5.0

There is no limit to the number of set commands per route map, but keep the number of set filters in a route-map low. The set commands do not require a corresponding match command.

• Enter the IP address in A.B.C.D format of the next-hop for a BGP route update in ROUTE-MAP mode.

  set ip next-hop address

• Enter an IPv6 address in A::B format of the next-hop for a BGP route update in ROUTE-MAP mode.

  set ipv6 next-hop address

• Enter the range value for the BGP route’s LOCAL_PREF attribute in ROUTE-MAP mode, from 0 to 4294967295.

  set local-preference range-value

• Enter a metric value for redistributed routes in ROUTE-MAP mode, from 0 to 4294967295.

  set metric {+ | - | metric-value}

• Enter an OSPF type for redistributed routes in ROUTE-MAP mode.

  set metric-type {type-1 | type-2 | external | internal}

• Enter an ORIGIN attribute in ROUTE-MAP mode.

  set origin {egp | igp | incomplete}

• Enter a tag value for the redistributed routes in ROUTE-MAP mode, from 0 to 4294967295.

  set tag tag-value

• Enter a value as the route’s weight in ROUTE-MAP mode, from 0 to 65535.

  set weight value

Check set conditions

OS10(config)# route-map ip permit 1
OS10(conf-route-map)# match metric 2567