Dell EMC SmartFabric OS10 User Guide Release 10.5.0

INTERFACE-VIRTUAL-NETWORK

INTERFACE-VLAN

Configure the same anycast gateway IP address on all VTEPs in a VXLAN virtual network or a VLAN. Use the anycast gateway IP address as the default gateway IP address if the host VMs move from one VTEP to another in a VXLAN or VLAN. The anycast gateway IP address must be in the same subnet as the IP address of the virtual-network router.

Starting from release 10.5.2, you can use this command to configure an anycast IPv4 address for a VLAN interface. This command allows you to configure anycast IP gateway for up to 512 VLANs. The anycast IP address may optionally be configured with a 32-bit subnet mask. Make sure the anycast IP address is different from the primary IP address. To assign an anycast IPv6 address to a VLAN interface, use the ipv6 virtual-router address command. Prior to assigning the anycast IP address to a VLAN interface, configure a virtual MAC address to the switch using the ip virtual-router mac-address command. All virtual addresses on all VLAN interfaces resolve to the configured virtual MAC address.

The no version of the command removes the specified anycast IP address from a VXLAN virtual network or a VLAN interface.

OS10(config)# interface virtual-network 10000
OS10(config-if-vn-10000)# ip virtual-router address 10.1.0.100

OS10(config)# interface vlan 100
OS10(conf-if-vl-100)# ip virtual-router address 10.10.10.3

• 10.4.3.0 or later
• 10.5.2.0 or later—Support for Interface VLAN added.