Dell EMC SmartFabric OS10 User Guide Release 10.5.0

ip pim [vrf vrf-name] rp-candidate-timers {ethernet node/slot/port[:subport] | loopback loopback-interface-number | vlan vlan-number | port-channel port-channel-number} {advt-interval interval-value} [hold-time hold-time-value]

• vrf vrf-name—Enter the keyword vrf, then the name of the VRF
• loopback-interface-number—Enter a value from 0 to 16383
• vlan-number—Enter a value from 1 to 4093
• port-channel-number—Enter a value from 1 to 128
• interval-value—Enter a value from 1 to 26214
• hold-time-value—Enter a value from 1 to 65535
  NOTE The hold time must be greater than the advertisement interval.

• Advertisement interval is 60 s.
• Hold time value is 150 s.

Use this command to adjust the interval between candidate RP advertisements. The advertised RP entries remain in the node until the hold time value expires. Dell EMC recommends configuring the hold time value to be 2.5 times the advertisement interval. The no form of the command resets the candidate RP timers to the default values.

OS10# configure terminal
OS10(config)# ip pim vrf red rp-candidate-timers loopback 10 advt-interval 30 hold-time 80