Dell EMC SmartFabric OS10 User Guide Release 10.5.0

VRRP uses the VRID to identify each virtual router configured. Before using VRRP, you must configure the interface with the primary IP address and enable it.

• Create a virtual router for the interface with the VRRP identifier in INTERFACE mode, from 1 to 255.

  vrrp-group vrrp-id 

• Delete a VRRP group in INTERFACE mode.

  no vrrp-group vrrp-id

Configure VRRP

OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)# vrrp-group 254

Verify VRRP

OS10(conf-eth1/1/5-vrid-254)# do show running-configuration
...
!
interface ethernet 1/1/5 
ip address 10.10.10.1/24
! 
vrrp-group 254 
no shutdown
...