Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Assign an interface to a non-default VRF instance

1. Enter the interface that you want to assign to a non-default VRF instance.
   CONFIGURATION
   interface ethernet 1/1/1
2. Remove the interface from L2 switching.
   INTERFACE
   no switchport
3. Assign the interface to a non-default VRF.
   INTERFACE CONFIGURATION
   ip vrf forwarding vrf-test
   Before assigning an interface to a VRF instance, ensure that no IP address is configured on the interface.
4. Assign an IPv4 address to the interface.
   INTERFACE CONFIGURATION
   ip address 10.1.1.1/24
5. Assign an IPv6 address to the interface.
   INTERFACE CONFIGURATION
   ipv6 address 1::1/64
   You can also auto configure an IPv6 address using the ipv6 address autoconfig command.
   NOTE Before configuring any routing protocol in a VRF instance, you must first assign an IP address to at least one of the interfaces assigned to the VRF instance on which you want to configure routing protocols.