Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

Dell EMC PowerEdge R240 Installation and Service Manual

PDF

System health and system ID indicator codes

The system health and system ID indicator is located on the left control panel of your system.

Figure 1. System health and system ID indicator

This image shows system health and system ID indicator.

Table 1. System health and system ID indicator codesThis table describes the system health and system ID indicators. Item 1 indicates Solid blue where the condition indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode. Item 2 indicates Blinking blue where the condition indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode. Item 3 indicates solid amber where the condition indicates that the system is in fail-safe mode. If the problem persists, see the Getting help section. Item 4 indicates blinking amber where the condition indicates that the system is experiencing a fault. Check the System Event Log, if available on the bezel, for specific error message. For information about the event and error messages generated by the system firmware and agents that monitor system components, go to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it up..
System health and system ID indicator codeCondition
Solid blue Indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode.
Solid amberIndicates that the system is in fail-safe mode. If the problem persists, see the Getting help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log for specific error messages. For information about the event and error messages generated by the system firmware and agents that monitor system components, go to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it up.

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \