Passa al contenuto principale
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.

Dell OpenManage Server Administrator Version 7.4 Command Line Interface Guide

BIOS Setup Groups On PowerEdge yx2x Systems

The following table lists the available groups of the BIOS setup parameters on PowerEdge yx2x systems.
  • NOTE: Based on the hardware configuration, the attributes may vary in a specific group.
Table 1. BIOS Setup Groups On PowerEdge yx2x Systems
Group Description
BIOS Boot Settings Controls the system boot settings when bootmode is set to bios.
Boot Settings Controls the system boot settings when bootmode is set to bios.
Embedded Server Management Sets up the Embedded Server Management options.
Integrated Devices Controls the devices integrated on the system board.
Memory Settings Controls the system memory settings.
Miscellaneous Settings Controls some miscellaneous system settings.
One-Time Boot Supports one-time boot to a specified device.
Processor Settings Controls the processor(s) settings of the system.
SATA Settings Control the embedded SATA ports settings.
Serial Communication Controls the Serial Communication options.
Slot Disablement Controls the system slots that are present on the system.
System Information Displays the information that uniquely identifies the system.
System Profile Settings Controls the power management settings.
System Security Controls the security features of the system.
UEFI Boot Settings Controls the system boot settings when boot mode is set to uefi.

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \